This chapter describes Easy Start Functions (EZ) messages. For information on message content and how to use the message, refer to the Introduction.
| EZ.001 |
Level: ALWAYS
Short Syntax: EZ.001 Starting.
Long Syntax: EZ.001 Starting.
Description: EasyStart process has begun.
| EZ.002 |
Level: ALWAYS
Short Syntax: EZ.002 Changed one or more cfg params.
Long Syntax: EZ.002 Changed one or more configuration parameters.
Description: EasyStart changed a data link (e.g., PPP to FR), or changed a data link parameter in permanent configuration. EasyStart restarts for the changes to take effect.
| EZ.003 |
Level: ALWAYS
Short Syntax: EZ.003 Bootp failed.
Long Syntax: EZ.003 Called bootp client and it failed
Description: EasyStart called BOOTP and it failed either because there is no BOOTP server on the attached (working) segment or because you did not configure the BOOTP server correctly.
| EZ.004 |
Level: ALWAYS
Short Syntax: EZ.004 Rcvd boot info: ipAddr ipAddr, ipMask ipMask on intf interfaceNumber
Long Syntax: EZ.004 Received boot info: IPaddr: ipAddr, mask: ipMask on interface: interfaceNumber
Description: EasyStart called BOOTP and received necessary information to perform a TFTP download of needed configuration parameters. EasyStart will update the IP configuration with an IP address and a mask. Then, EasyStart will reboot the system for the changes to take effect.
| EZ.005 |
Level: ALWAYS
Short Syntax: EZ.005 TFTP failed. Backing up to device configuration step.
Long Syntax: EZ.005 TFTP failed. Backing up to device configuration step.
Description: EasyStart TFTP transfer failed. EasyStart will go back to the device configuration step and try again.
| EZ.006 |
Level: ALWAYS
Short Syntax: EZ.006 All dlinks/parameters tried but failed; resetting to def values.
Long Syntax: EZ.006 All datalinks and parameters tried but failed; resetting; restarting.
Description: The router tried all data links and parameters but failed. EasyStart will reset the configuration and start from the beginning.
| EZ.007 |
Level: ALWAYS
Short Syntax: EZ.007 Waiting up to seconds seconds for devices to pass self-test.
Long Syntax: EZ.007 Waiting up to seconds seconds for devices to pass self-test.
Description: EasyStart is waiting for devices to pass self-test. The result is to have the device in the up or down state. Since some devices may come up quickly, there is a variable timer to avoid waiting.
| EZ.008 |
Level: ALWAYS
Short Syntax: EZ.008 TFTP transfer completed successfully. *** EasyStart Completed Successfully ***
Long Syntax: EZ.008 TFTP transfer completed successfully.
Description: EasyStart succeeded. The router is restarting to the operational configuration which was downloaded.
| EZ.009 |
Level: ALWAYS
Short Syntax: EZ.009 *** Restarting Router ***
Long Syntax: EZ.009 Restarting router
Description: Parameters have changed. EasyStart is restarting to have the changes take effect.